All Collections
ReconPro Classic Back Office
Monitor
Configure auto-completion of repair order phase after inspection approval
Configure auto-completion of repair order phase after inspection approval
Serhii Toropov avatar
Written by Serhii Toropov
Updated over a week ago

You can enable the Autocomplete Inspection setting that automatically completes a repair order phase when a linked inspection of a particular type is created and approved. 

Note The start date & time and the completion date & time of the phase are populated automatically based on inspection creation date & time and approval date & time respectively. 

To turn on the Autocomplete Inspection setting

  • On the Monitor tab, click Repair Locations, and then click the Phases link for the appropriate repair location.

  • On the Phases page, click Edit next to the appropriate phase. 

  • In the Phase dialog box, select the Autocomplete Inspection check box, and click OK.

Note If the Autocomplete Inspection check box is selected, the Check-Out option and the Start Service Required check box are disabled.

Did this answer your question?